Motorcycle cover is an important equipment to protect the motorcycle from dust, rain, ultraviolet and other external factors. The following is the proper use of motorcycle cover to help you better protect your car.
First, prepare the gown
1. Before using the motorcycle cover, please ensure that your motorcycle has been parked in a flat, dry, and windless place to avoid accidents during the overdressing process.
2. Check whether the motorcycle cover is intact. If there is damage or stains, please clean or repair it first.
Two, spread the car clothes
1. Lay the motorcycle cover flat on the ground to ensure that the inside and outside surfaces of the cover are clean and free of foreign bodies.
2. Turn the open part of the motorcycle cover towards the direction of the motorcycle, ready to cover the operation.
Third, fix both sides
1. Starting from the front of the motorcycle, gently pull up the sides of the cover-up and cover the sides of the motorcycle.
2. Be careful not to pull the overalls too tightly to avoid damaging the motorcycle or overalls.
3. If necessary, the position of the garment can be adjusted appropriately to ensure that the coverage area is large enough to fully wrap the motorcycle.
Four, set before and after tight
1. Next, pull the front of the cover-up back over the front part of the motorcycle.
2. Then, pull the back of the cover-up forward to cover the rear part of the motorcycle.
3. Before and after the set, ensure that the cover is closely fitted with all parts of the motorcycle, leaving no gaps.
5. Fix the buckle
1. Most motorcycle covers come with a retaining clip or rope to hold the cover to the motorcycle.
2. Find the buckle or rope on the cover-up and connect it to the appropriate part of the motorcycle.
3. Make sure the buckle or rope is strong and reliable to prevent the garment from swaying in the wind or being blown away.
Six, lock the hoop
1. Some premium motorcycle covers are also equipped with hoops and locks for further safety.
2. If your motorcycle cover is equipped with a hoop and lock, pass the hoop through the specific location of the cover and use the lock to lock it.
3. After locking the iron ring, you can ensure that the motorcycle cover is still strong and reliable when unguarded.
With the above steps, you have successfully placed the motorcycle cover over the motorcycle. Please note that when using a motorcycle cover, check and clean the cover regularly to ensure that it is always in good condition. At the same time, when storing the motorcycle cover, it is also necessary to avoid exposing it to the sun or wet environment to extend its service life.